|Drying and Curing Instructions:||– Let dry for 1-4 hours at room temperature
– Recommended to be cured at 200°F for 2 hours
– Then at 500°F for 2 hours before use
|Maximum Operating Temperature:||1600 °C|
Typical Use Guidelines
Typical testing ramp rate is more dependent on the cell rather than the seal, we recommend a heating rate of 1-2°C/minute.
The paste can be cured in-situ with the test assembly that it is being used for sealing.
The thinner for high temperature sealing paste should only be used with this high temperature sealing paste. The thinner is used to change the viscosity of the paste to help with your specific sealing need. The thinner contains the solvent and binder solution that is already within the high temperature sealing paste.
Ask a Question
“Anode-Supported Solid Oxide Fuel Cells with Thin Film Electrolyte for Operation at Reduced Temperatures”
– Air Force Research Laboratory and UES Corp.